 | | Product SKUs |  |
| SYS-8211-RT4-UIO-F-M5 | | SuperServer 8211-RT4-UIO-F (Black) |
 |
| |
| | Motherboard | |
| Dual XEON® 5500/5600 Serverboard |
|
| |
| | Processor & Cache | |
| CPU | • | Dual 1366-pin LGA Sockets |
| | • | Supports up to two Intel® 64-bit |
| | | Xeon® processor(s) of the same |
| | | type below: |
| | • | Sixcore/Quadcore Intel® Xeon® |
| | | Processor 5600 sequence |
| | | (Westmere processor) |
| | • | Quadcore/Dualcore Intel® Xeon® |
| | | Processor 5500 sequence |
| | | (Nehalem processor) |
|
| QPI | • | up to 6.4 GT/s |
|
| |
| | System Memory | |
| Memory | • | Twelve 240-pin DIMM sockets |
| Capacity | • | Supports up to 192 GB 1333 / 1066 / |
| | | 800MHz DDR3 ECC Registered memory |
| | • | Memory Mirroring supported |
| | • | 12 DIMM sockets (6 per CPU) |
| | • | Memory must be populated in triples |
| | | for each CPU |
|
| Memory | • | 1333 / 1066 / 800MHz Registered |
| Type | | ECC DDR3 SDRAM 72-bit, |
| | | 240-pin gold-plated DIMMs |
|
| DIMM Sizes | • | 1GB, 2GB, 4GB, 8GB, 16GB |
|
| Memory | • | 1.5 V |
| Voltage | | |
|
| Error | • | Corrects single-bit errors |
| Detection | • | Detects double-bit errors |
| | | (using ECC memory) |
| | • | Supports Intel® x4 and x8 Single |
| | | Device Data Correction (SDDC) |
|
| |
| | On-Board Devices | |
| Chipset | • | Intel® 5520 (Tylersburg 36D) chipset |
| | • | ICH10R + IOH-36D |
|
| SATA | • | Intel ICH10R SATA 3.0Gbps Controller |
| | • | RAID 0, 1, 5, 10 support (Windows) |
| | | RAID 0, 1, 10 support (Linux) |
|
| IPMI | • | Support for Intelligent Platform |
| | | Management Interface v.2.0 |
| | • | IPMI 2.0 with virtual media over |
| | | LAN and KVM-over-LAN support |
| | • | Winbond® WPCM450 BMC |
|
| Network | • | Intel® 82576 Dual-Port Gigabit Ethernet |
| Controllers | | Controller |
| | • | Supports 10BASE-T, 100BASE-TX |
| | | and 1000BASE-T, RJ45 output |
| | • | Intel® I/OAT 3 support for fast, |
| | | scaleable, and reliable networking |
| | • | VMDq support for better performance |
| | | virtualization |
|
| Graphics | • | Matrox® G200eW 8MB DDR2 |
|
| Super I/O | • | Winbond 83627HF chip |
|
| |
| | |
| | Expansion Slots | |
| PCI-Express | • | Left Side: |
| | | 1 (x16) PCI-E 2.0 + 1 UIO slots OR |
| | | 1 (x16) PCI-E 2.0 |
| | | (Riser card required) |
| | | (Riser card required) |
|
| NIC | • | Right Side: |
| | | 2 LAN ports optional |
| | | (Riser card required) |
|
| |
| | Input / Output | |
| Serial ATA | • | Six Serial ATA ports |
| | • | Six SATA hard drives supported |
|
| LAN | • | 2x RJ45 LAN port |
|
| USB | • | 4x USB rear ports |
| | • | 2x USB on-board |
| | • | 2x USB internal headers OR |
| | • | 2x USB front ports (optional) |
| | • | Total 8 USB 2.0 Compliant |
|
| VGA | • | 1x VGA Port |
|
| Keyboard / | • | PS/2 keyboard and mouse ports |
| Mouse | | |
|
| Serial Ports/ | • | 1x Fast UART 16550 serial port |
| Header | • | 1x Fast UART 16550 serial header |
|
| |
|
|
| | System BIOS | |
| BIOS Type | • | 32Mb SPI Flash EEPROM with |
| | | AMI ® BIOS |
|
| BIOS | • | Plug and Play (PnP) |
| Features | • | PCI 2.2 |
| | • | ACPI up to 3.0 |
| | • | USB Keyboard support |
|
| |
| | Chassis | |
| Form Factor | • | 1U Chassis |
|
| |
| | Dimensions | |
| Height | • | 43mm |
|
| Width | • | 437mm |
|
| Depth | • | 650mm |
|
| Weight | • | ~20kg (depends on Config) |
|
| Available Colors | • | Black, Silver |
|
| |
| | Front Panel | |
| Buttons | • | Power On/Off button |
| | • | System Reset button |
| | • | UID Button |
|
| LEDs | • | Power LED |
| | • | Hard drive activity LED |
| | • | 2x Network activity LEDs |
| | • | Universal Information (UID) LED |
|
| Ports | • | 2x USB & DB9 COM port tray |
| | • | (Optional - in place of floppy drive) |
|
| |
| | Drive Bays | |
| Hot-swap Bays | • | 4x 3.5" SAS / SATA Hot-swap drive |
| | | bays |
|
| Peripheral Bay | • | 1x Slim DVD Drive Bay |
| | • | 1x Slim FDD Drive Bay |
|
| |
| | Peripheral Drives | |
| DVD | • | DVD ROM Drive |
| FDD | • | FDD Drive 1.44MB (optional) |
|
| |
| | System Cooling | |
| Fans | • | 4x 4cm Counter-rotating Fans |
| | • | 2x Power Supply Fan |
|
| |
| | SAS / SATA Backplane | |
| 1x 1U SAS / SATA backplane |
|
| |
| | Power Supply | |
| (1 + 1) Redundant 650W AC power supply w/ PFC |
|
| AC Voltage | • | 100 - 240V, 50 - 60Hz, 8 - 4Amp |
|
| +5V | • | 25 Amp |
|
| +5V standby | • | 3 Amp |
|
| +12V | • | 54 Amp |
|
| -12V | • | 0.5 Amp |
|
| +3.3V | • | 12 Amp |
|
| |
| | Management | |
| Software | • | Super Doctor III |
|
| Power | • | ACPI / ACPM Power Management |
| Configurations | | |
|
| |
| | PC Health Monitoring | |
| CPU | • | Monitors for CPU Cores, +1.8V, +3.3V, |
| | | +5V, ±12V, +3.3V Standby, +5V Standby, |
| | | VBAT, HT, Memory, Chipset Voltages. |
| | • | 6-Phase-switching voltage regulator with |
| | | auto-sense from 0.8375V-1.60V |
|
| FAN | • | Total of six 4-pin fan headers |
| | | supporting up to 6 Fans |
| | • | 6x fans with tachometer status |
| | | monitoring |
| | • | Status monitor for speed control |
| | • | Status monitor for on/off control |
| | • | Low noise fan speed control |
| | • | Pulse Width Modulated (PWM) |
| | | fan connectors |
|
| Temperature | • | Monitoring for CPU and chassis |
| | | environment |
| | • | CPU thermal trip support |
| | • | FC temperature sensing logic |
| | • | Thermal Monitor 2 (TM2) support |
| | • | PECI |
|
| LED | • | CPU / System Overheat LED |
|
| Other | • | Chassis intrusion detection |
| Features | • | Chassis intrusion header |
| | • | SDDC Support |
|
| |
|
|
|
|
Produkte
Symbolfotos
